DKS MicroPLUS 8055 Manuel d'instruction - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} DKS MicroPLUS 8055. DKS MicroPLUS 8055 2 pages. Rf receiver

Imprimer la page
Programming
Programming Transmitter Codes:
flashes ONE time, then release the button. The programming LED will flash once every two seconds indicating that you are in the transmitter
programming mode....
Press
START
and
Hold
Button
....While the programming LED is flashing, activate each of the MicroPLUS
transmitter, make sure to press the correct button). A maximum of 40 transmitters codes can be stored in this receiver.
Once the desired transmitter codes have been stored into the receiver memory, the receiver will automatically exit the programming mode when no
more transmitter codes are received (approx. 30 seconds idle time). This will be indicated by a series of 10 quick flashes followed by a long flash.
All Desired
2 Sec.
®
MicroPLUS
Transmitters
have been Activated
Transmitter Programming Mode
Erase All Transmitter Codes:
then THREE times, then FOUR times for three times in a row (about 12 seconds total for the whole sequence), then release the button. Five
seconds after releasing the button, the LED will emit ONE long flash indicating ALL memory (transmitter codes) have been erased.
Press
and
Hold
Button
Once
Twice
This device complies with the FCC Rules Part 15. Operation is subject to the following two conditions:
1.) This device may not cause harmful interference.
2.) This device must accept and interference received, including interference that may cause undesired operation.
This class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.
8055-065-B-8-11
Press and hold the programming push button (about 2 seconds) until the programming LED quickly
2 Sec.
Release
Button
One Quick Flash
Approximately 30 Seconds Idle Time
2 Sec.
Press and hold the programming push button until the programming LED quickly flashes ONCE, then TWICE,
Approximately 12 Seconds
Three Times
Four Times
Copyright 2011 DoorKing, Inc. All rights reserved.
Programming Push Button
Programming LED
2 Sec.
2 Sec.
2 Sec.
Transmitter Programming Mode
®
transmitters that will be used (If you are using a two or three button
2 Sec.
Four Times
Three Times in a Row
8055-080
Built-In Antenna
2 Sec.
2 Sec.
10 Quick Flashes
Four Times
Inglewood, California 90301
DoorKing Part Numbers
8055-081
Coax Antenna Kit
Activate All Desired
®
MicroPLUS
Transmitters
FINISH
One
Long
Flash
5 Sec.
Release
Button
One
Long
Flash
120 Glasgow Avenue
U.S.A.