DKS 1520 series Manuel d'installation et d'utilisation - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} DKS 1520 series. DKS 1520 series 16 pages. Stand alone card readers or controller
Également pour DKS 1520 series : Manuel (2 pages)
Imprimer la page
1.2 Mount Cabinet Continued
Controller Mounted Directly
to a Wall or Pilaster
Use the 4 existing holes in
the cabinet. Run conduit
outside of wall or pilaster.
Use appropriate hardware to
mount the cabinet (Not
supplied). Be sure that the
mounting hardware does not
protrude into the cabinet
where it could cause a short.
1.3 Re-install Components into Cabinet
IMPORTANT:
Be sure to clean out the cabinet of any debris that can cause a short.
All necessary wiring should be connected to the 18-pin terminal. See Section 1.4 1520 Wiring.
1520 Controller: Re-install four (4) 6-32 x ¼ screws into the corners of the keypad mounting plate.
1520 Card Reader: Re-install Card Reader faceplate with the 2 locknuts. Re-install four (4) 6-32 x ¼ screws into the corners of
the keypad mounting plate. See page 13 for wiring schematics.
Master Code Note: The default MASTER CODE is 9999. If you would like to change the master code, refer to Section 2.1 to
re-program the master code prior to re-installing the keypad mounting plate. 1520 must have power to re-program master
code.
1520-065-E-7-16
Plastic screw anchors
for masonry if required.
(Not supplied)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
MASTER
CODE
1505
009
1000
Run ALL wires that will be
needed during the cabinet
installation and connect to
18-pin terminal. See Section
1.4 1520 Wiring.
3/4" Conduit
15
16
17
18
18-Pin Terminal
Master Code Push Button
5