CUTRA WC40000F25W Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} CUTRA WC40000F25W. CUTRA WC40000F25W 17 pages.

* About blade and blade fixture

1. In order to transmit the ultrasonic waves, fix the product with the adequate

blade and blade fixture.

* Make sure that the blade and its fixture are correctly fixed.

2. The stain on the blade or on its fixture can cause heat, noise, and damage

of the product.

* Make sure the product is stainless, and change if there are any stain on

the blade or its fixture.

When changing the blades

Insert the dead end of the blade that will be changed into the inside of

the blade fixture. Line up the holes of blade setscrew and the blade fixture.

When changing blade fixture

Line up the holes of the blade setscrew and the new blade fixture.

Cautions

Lastly

Make sure that the blade and its fixture is correctly set, and tighten the

setscrew with a hexagonal wrench.

Cautions

Blade fixing screw

Blade fixture

Be careful with the dead end of blade and the direction of blade.

Use the designated blades only.

When other than designated blades are used, the product might

not operate correctly and this can cause breakdown or fall out

of the blades.

When the blade is not correctly adjusted, a buzzer beeps and

the handle power button does not operate.

Tighten the setscrew of blade.

When the setscrew is not correctly adjusted, the blade can pop

out and this may cause accidents and cause of breakdown.

Change the hexagonal wrench when worn down.

Ask for the manufacturer's help when the setscrew does not fall

out.

When the blade has been changed while the vibrator produces heat,

the setscrew can loosen when the temperature goes down.

Make sure that the setscrew is correctly fixed before using the product.

Product management

Blade