CUTS DIAMANT MC 301 Manuel d'utilisation et d'entretien - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} CUTS DIAMANT MC 301. CUTS DIAMANT MC 301 4 pages.

Imprimer la page

4) OPERATION

4.1) BLADE FIXING

To fix the blade follow the instructions:

1. Lift up the blade guard

2. Unscrew the nut on blade shaft (anticlockwise thread)

3. Remove outer flange

4. Make sure that flanges and blade shaft are perfectly clean

5. Fit the blade so that the arrow on the blade label and the arrow on the guard are

in the same direction

6. Fit back the outer flange and tighten the nut on blade shaft

7. Make sure that the blade is correctly aligned

8. Close the blade guard

9. Make sure that the blade is completely off the ground

10. Start the engine

4.2) ENGINE STARTING

ATTENTION: when using the machine for the first time, refer to the engine

manual.

To start the engine with the recoil starter, follow the instructions:

1. Open the fuel cock

2. Set the accelerator lever as shown in the picture

3. Set the selector to ON

4. Hold the handle tightly to start the engine. Make sure that your position will allow

a free movement of your arm. Caution! Pull the cord with force to prevent kickback

5. Let the engine warm up for a few minutes

6. To switch the engine off set the ON/OFF selector to OFF.

To stop the engine in case of failure of the ON/OFF selector set the accelerator to

the minimum and close the fuel cock

4.3) JOINT CUTTER USE

After mounting the blade and starting the engine, start cutting as follows:

1. Open the water cock on the cart and make sure that the blade cooling system

is working properly

2. Use the hand-wheel to lower the blade gradually and uniformly until you reach

the required cutting thickness

3. Align the guide rod with the required cutting direction

4. Push the machine gradually and uniformly by using the handles

5. Once finished cutting, turn the hand-wheel to eject the blade

6. Switch the engine off (see 4.2 – 6)

WARNINGS

• It is recommended to use Cuts Diamant diamond blades

• Add fuel only when the machine is off. Prevent fuel from coming into contact with

hot parts of the machine and of the engine

• Check the tank and the cap

ATTENTION! Replace tank and cap immediately if defective to avoid explosion

(Tank)

• Turn off the fuel cock when the machine is not in use

• Pay attention when handling chemical substances (lubricating oil and fuel)

• Do not use the machine in environments where gas fumes may be present

• Do not use the machine in closed environments (insufficient ventilation)

• Do not smoke or use naked flames near the machine

• Always operate in safe and stable conditions to avoid damage to people or objects

• When not in use, switch the engine off and leave the machine in a safe and

sheltered place. Avoid temperatures below -10° C and above +60° C

(Fuel cock)