Artos Engineering Company CD-17 Manuel du propriétaire - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Artos Engineering Company CD-17. Artos Engineering Company CD-17 4 pages. Coiling bowls
Imprimer la pageWARNING
NEVER REACH INTO THE COILING BOWL WHILE IT IS TURNING. INJURY MAY RESULT
CD‐17 Operator controls
The dial 0‐100 controls the winding rate of the bowls. The faster the wire is fed in the CS327 machine
the higher this number needs to be.
The Clutch pressure controls how tightly the bowl is held to the rotating drive mechanism. You want to
adjust this value so that the bowl is able to rotate and collect the wire, but at the same time if the wire
stops feeding the bowl will stop also. In addition if an operator puts their hand in it while it is still
rotating it will stop easily. If the bowl keeps rotating when the wire stops feeding, the wire in the bowl
will be pulled out and twisted. It works best to start with a low value like 20PSI and increase it until you
notice that the bowl properly coming up to speed for the wire to feed in. The item that affects this
setting is the weight of the wire in the bowl. When you have a coil that is very heavy the clutch pressure
should be reduced.
The Brake pressure controls how fast the bowl comes to a stop. If this value is set too high the bowl will
stop and the wire in the bowl will keep spinning thus causing a tangle. The item that affects this setting
is the weight of the wire in the bowl. When you have a coil that is very heavy the brake pressure will
have to be increased.
2