CVS Controls 1200 Manuel d'instruction - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} CVS Controls 1200. CVS Controls 1200 11 pages. Pneumatic positioner

Imprimer la page

Installation

Linear:

1. Mount bracket with two 5/16"x1"

bolts to actuator. Leave bolts loose at

this point.

2. Mount positioner to bracket with

two 8mmx1-1/2 bolts and spacers.

Leave bolts loose at this point

3. Install threaded shaft into

connecting block.

4. Apply air to actuator until valve is

at 50%.

5. Using link bearings and link,

connect from threaded shaft to

positioner travel arm.

Note: Travel arm is metric.

6. Tighten link bearings to travel arm

with ¼" bolt and nut. Adjust nuts on

threaded shaft until link is parallel

with actuator. Then tighten.

7. Slide positioner until link is parallel

with actuator stem. Tighten bolts.

8. Adjust link so that the travel arm

forms a right angle to the actuator.

Tighten bolts.

9. Apply air to actuator until travel is

100%. Inspect to ensure travel arm is

not touching stopper on back side of

the positioner. If so, adjust link

bearing bolt on travel arm

accordingly.

10. Remove air from actuator and

inspect down travel stop. Adjust

accordingly.