ALUZ A1-ZIBI-STN-DWH Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ALUZ A1-ZIBI-STN-DWH. ALUZ A1-ZIBI-STN-DWH 13 pages.

Measure area where luminaire will be installed. Use a laser line

to create a reference along installation area, ensuring accurate

placement of mounting clips. Mark location where each mounting

clip will be installed along reference line.

The number of required mounting clips differs for dry and wet

location products. Verify number of mounting clips is appropriate

for installation environment before beginning installation. Do not

install luminaires with inadequate number of mounting clips. Refer

to the Mounting Clips page for additional information.

Lay mounting clips along reference line and pre-drill surface using

an appropriate drill bit for surface and screw size.

Recommendation: 8/32 x 1" Screw.

Note: Allow 1/4" clearance for lateral expansion of assembled

mounting clips. Only install mounting clips on flat, even surfaces.

If applicable, connect disconnects between luminaire segments.

Slide shrink tube over connectors and apply heat. The shrink tube

will shrink down, sealing the connectors. Apply silicone around

sealed connectors for a stronger seal.

Note: Only use a heat gun to apply heat to shrink tubes. Do not use

an open flame such as a lighter or gas torch.

1170 N Red Gum St, Anaheim, CA 92806

aluz.lighting

A1 Series | Surface

ZIBI Standard Dynamic White

(A1-ZIBI-STN-DWH)

866.ALUZ.LTG | 714.535.7900

Screw mounting clips to surface, then snap luminaire into mounting

clips. Install set screws if required. Set screws are required for

downward and outward facing applications.

Perform a continuity test before connecting to power source.

Refer to Continuity Test for details.

Verify wiring diagram, then connect luminaire to power source.

Page 7 of 13

Wet Location Mounting

Installation Instructions

9 / 11 / 2023 / Rev 4