ALUZ ZIBI A1 Series Manuel d'instructions d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 12 pages. Surface zuco pivot bios illuminated
Également pour ALUZ ZIBI A1 Series : Manuel (11 pages), Manuel (13 pages), Manuel (11 pages), Manuel d'instructions d'installation (11 pages)

Imprimer la page
1
Measure area where luminaire will be installed. Use a laser line to create a
reference along installation area, ensuring accurate placement of mounting
clips. Mark location where each mounting clip will be installed along
reference line.
2
The number of required mounting clips differs for dry and wet location
products. Verify number of mounting clips is appropriate for installation
environment before beginning installation. Do not install luminaires with
inadequate number of mounting clips. Refer to the Mounting Clips page for
additional information.
3
Lay mounting clips along reference line and pre-drill surface using an
appropriate drill bit for surface and screw size.
Recommendation: 8/32 x 1" Screw.
Note: Allow 1/4" clearance for lateral expansion of assembled mounting clips.
Only install mounting clips on flat, even surfaces.
4
If applicable, connect disconnects between segments and push together,
leaving no gap. Use a mounting clip at the junction between two segments.
Push together,
leaving no gap
5
If applicable, connect jumper cable disconnects between segments. Install
end cap screws to connect end cap to segment.
End Cap Screws
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard RGBW
(A1-ZIBI-STN-RGBW)
Ensure connections are secure
Mounting Clip holds
segments together
Do not leave gaps
or pinch wires
Ensure connections are secure
Jumper Cable
(1.75" Minimum Bend Radius)
866.ALUZ.LTG | 714.535.7900
6
Screw MC-1 mounting clips to surface, then snap luminaire into mounting
clips. Install set screws if required. Set screws are required for downward and
outward facing applications.
Set Screw
7
If applicable, connect power cord disconnects to luminaire segment. Install
end cap screws to connect end cap to segment.
Note: Standard luminaire provided with 1 factory installed 6' power cord and
1 end cap at the end of each run. Power cord is easily relocated by unscrewing
end cap and undoing disconnects.
End Cap Screws
Power Connector
8
Perform a continuity test before connecting luminaire to power source.
Refer to Troubleshooting & Continuity Test page for additional information.
9
Verify wiring diagram, then connect luminaire to power source.
Dry Location Mounting
Ensure connections are secure
6'
Installation Instructions
4 / 29 / 2022 / Rev 2
Page 6 of 12