ALUZ ZIBI A1 Series Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 13 pages. Surface zuco pivot bios illuminated
Également pour ALUZ ZIBI A1 Series : Manuel d'instructions d'installation (12 pages), Manuel (11 pages), Manuel (11 pages), Manuel d'instructions d'installation (11 pages)

Imprimer la page
1
Measure area where luminaire will be installed. Use a laser line to
create a reference line along installation area, ensuring consistent
alignment of mounting arms. Mark location where each mounting
arm will be installed along reference line.
2
Determine number of mounting arms needed. Use a minimum
of 2 mounting arms per luminaire. Mount arms 6" from center of
mounting plate to the end of luminaire.
Note: Refer to Spacing Diagrams on next page for details.
3
Screw arm base to surface using countersink screws of appropriate
type and length for surface material and weight of fi xtures.
4
Secure luminaire to mounting plates by installing provided #6-20
countersink screws through countersink holes in the bottom of the
plate. Ensure luminaire is secured in place and spacing is accurate
according to the Spacing Diagrams.
5
Loosen set screw until the mounting plate can move freely. Turn
the mounting plate until desired angle is achieved, then mate the
locking bump with locking hole. Tighten set screw until mounting
plate is secured in place.
Note: Refer to Angle Increments diagram next page.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard Dynamic White
(A1-ZIBI-STN-DWH)
866.ALUZ.LTG | 714.535.7900
6
If applicable, connect disconnects between luminaires. Slide
shrink tube over connectors and apply heat. The shrink tube will
shrink down, sealing the connectors. Apply silicone around sealed
connectors for a stronger seal.
ASSEMBLED DIMENSIONS
2.52"
4.42"
2.60"
5.43"
X
With Louver
SPACING DIAGRAMS
Example: 4' Run
3"
Example: 8' Run
3"
3'-6"
4'
Bottom Mount Adjustable Arm
(A1-ZIBI-STN-AA-BM-X)
2.0"
X
No Accessories
2.60"
5.43"
2.0"
X
With Reflector
3'-6"
3"
4'
3"
3"
3'-6"
4'
8'
Installation Instructions
9 / 11 / 2023 / Rev 4
Page 8 of 13
2.0"
3"