Alva EIH200 Manuel - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Alva EIH200. Alva EIH200 9 pages. Electric convection heater
5.
Using a screwdriver, insert the screws and secure the feet
securely to the heater body (Fig.1).
6.
Turn the heater to the correct position and place it onto an
even horizontal surface, ensuring that the heater is in an
upright position.
The heater is now ready for use.
USING YOUR HEATER
SELECTION KNOB
This knob is used for heating intensity function.
SWITCHING ON
Insert the plug into the wall socket to connect the heater to the
electric mains.
SELECTION OF HEATING POWER MODES
Choose a suitable location for the heater, taking into account
the safety instructions above.
Turn the thermostat knob fully in a clockwise direction to the
maximum setting.
Turn on the power by means of the selection knob on the side
panel. When the power is on, the power indicator will light up.
Then turn on the heating function by means of the function
selection knob "I" on the side panel. For maximum heat output
the selection knob should be turned to the most high-grade "II".
TEMPERATURE SETTING
Turn the thermostat knob clockwise up to the "MAX" position.
When temperature in the room reaches the desired level, slowly
turn the thermostat knob counterclockwise until it clicks. Now, the
thermostat will maintain an even temperature periodically, switch-
ing heating on and off, automatically.
In cold weather, place the thermostat knob to a level somewhat
higher than desired to achieve effective heating.
Fig.1
4
OPERATION OF THE
HEATER
NOTE: It is normal when the
heaters are turned on for the
first time or when they are
turned on after having not
been used for a long period
of time the heaters may
emit some smell and fumes.
This will disappear when the
heater has been on a short
while.
Before using the heater,
make sure you understand
the "IMPORTANT SAFETY
INFORMATION"
section of this manual.
SELECTION KNOB
INDICATOR LIGHT
THERMOSAT KNOB