Alva GH310S Instructions d'assemblage et d'utilisation

Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage et d'utilisation pour {nom_de_la_catégorie} Alva GH310S. Alva GH310S 8 pages. Indoor gas heater

LEAK TEST
Connection
in heater
assembly
Foamy bubbles
indicate a leak
The leak test must be carried out in a
or other sources of ignition.
1) With the cylinder connected to the
heater and the valve open, press down
the heater control knob.
the heater.
2) Brush all the connections (hose to valve,
hose to regulator, regulator into
cylinder) with a solution of equal parts
soap and water (make sure it's foamy).
3) A stream of bubbles forming indicates a
gas leak.
4) If bubbles appear, turn the cylinder
valve OFF (clockwise) and disconnect
the regulator from the gas cylinder.
5) Tighten the connection and retry the
leak test.
6) If you are unsure or if you cannot
tighten the connection, place the
cylinder outside in a cool,
well-ventilated area and contact Alva
on 086 100 ALVA (2582)
7) A leak between the regulator and
which is very dangerous and can lead to
extensive injury or even death.
FOR YOUR SAFETY
IF YOU SMELL GAS:
• TURN OFF GAS SUPPLY AT CYLINDER
• EXTINGUISH ALL NAKED FLAMES.
DO NOT OPERATE ANY ELECTRICAL
APPLIANCES.
• VENTILATE THE AREA
• CHECK FOR LEAKS AS DETAILED
IN THIS MANUAL
• IF ODOUR PERSISTS, CONTACT YOUR
DEALER OR GAS SUPPLIER IMMEDIATELY .
PRECAUTIONS
• LEAK TEST ALL CONNECTIONS AFTER
EACH TANK REFILL
• NEVER CHECK FOR LEAKS WITH A MATCH
OR OPEN FLAME
• DO NOT STORE OR USE GASOLINE,
OR OTHER FLAMMABLE VAPOURS
AND LIQUIDS IN THE VICINITY OF THIS
OR ANY OTHER APPLIANCE
• ANY LP GAS CYLINDER NOT CONNECTED
FOR USE MUST NOT BE STORED IN THE
VICINITY OF THIS OR ANY OTHER APPLIANCE
INDOOR GAS HEATER (GH310S)
Assembly and operating instructions
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE
Distributed and serviced by ALVA Marketing ( Pty) Ltd, P.O. Box 30014, Tokai, 7966
Tel: 082 100 ALVA (2582)• E-mail: [email protected] • www.alva.co.za
@StingrayGroupSA •
www.facebook.com/AlvaGas
WARNING
THIS IS A LOW PRESSURE APPLIANCE
TO BE USED ONLY WITH A 2.8kPa
SANS 1237 APPROVED REGULATOR
(REGULATOR FITTED AND SUPPLIED)
FOR YOUR OWN SAFETY,
PLEASE READ THIS MANUAL
CAREFULLY AND ALWAYS
OPERATE THIS PRODUCT ACCORDING
TO THE INSTRUCTIONS
IT IS ILLEGAL AND DANGEROUS
TO CHANGE OR MODIFY ANY PART
OF THIS APPLIANCE