Alvey 14WC2M Mode d'emploi

Parcourez en ligne ou téléchargez le pdf Mode d'emploi pour {nom_de_la_catégorie} Alvey 14WC2M. Alvey 14WC2M 2 pages. Deck winch reel

Congratulations and thank you for choosing an Alvey Reel

After firmly attaching the Deck Winch Reel to the rail or mounting system of your launch, the line is passed

between the roller runner and guide pin. The rig, bait and sinker are then attached and dropped overboard.

With the Star Nut slackened the sinker will quickly take your baited line down, but you must be ready to

stop the spool with your hand immediately the sinker hits the bottom to prevent overrun. You should then

tighten the Star Adjusting Nut to apply the desired tension on the line from the spool.

An adjustable overrun bar is provided (on some models) which is set close to the rim of the spool to prevent

the line from coming off the spool under normal circumstances; nevertheless, failure to stop overrun when

playing line out off a free spool could result in some loose coils of line getting caught around the axle. If this

should accidentally happen, it is often quicker and easier to remove the spool in order to free the line.

To remove the Spool: If the winch has double winding handles, remove the lock nuts and second handle

from the main shaft. Then remove the knurled centre screw (only applies to Reef Master) and unscrew the

Star Nut. Now, hold the spool firmly with one hand whilst the axle is withdrawn with the other. The line will

now free itself and the axle Star Nut and centre screw can be replaced ready for action.

When replacing the axle

the internal mechanism of the friction clutch.

The process of removing the spool, freeing the line and replacing it should take only a few seconds, but will

not be necessary if a little care is taken to prevent overrun when playing out line with a free spool.

Double winding handles on large winches will take a little longer to remove. The non-reversing friction clutch

is set to the desired tension by means of the Star Adjusting Nut or handwheel. As this can be adjusted at

any time whilst playing a fish, it is not necessary to set it to maximum tension for normal fishing. Reels can

be mounted on an optional swivel clamp to allow the reel to follow the direction of the line and this action can

be used to lay the line evenly on the spool when retrieving line. A crank screw is provided to prevent the

reel from swivelling if desired.

Alvey products are guaranteed against faulty materials or workmanship

Spare parts and service, if necessary, are readily available.

Maintenance: Wash off with fresh water after each use.

Major Service: Oil clutch washers (Remove clutch cover plates

Reel Icon Pty Ltd Trading as

Alvey Reels Australia ABN 57 625 261 707

2-6 Antimony Street Carole Park Qld 4300

t: +61 7 3271 2844 f: +61 7 3271 2451

it may be necessary to turn it until the slot in the axle engages the notches in

Oil handles and roller guides with light oil.

Oil or light grease in grease nipple occasionally

depending on use.

if applicable).

Instructions

for Use

For more hints and tips on maintenance, please

visit the spare parts page at www.alvey.com.au

#alveyreels