DLS CAD1000 Comment l'installer et l'utiliser - Page 6

Parcourez en ligne ou téléchargez le pdf Comment l'installer et l'utiliser pour {nom_de_la_catégorie} DLS CAD1000. DLS CAD1000 8 pages. Digital mono amplifier

Imprimer la page

Speaker wiring CAD 1000

One 4 ohm subwoofer

4 ohm load

Speaker

Filter settings

Subsonic

10Hz 60Hz

The Subsonic filter at 30 Hz and the LPF filter set-

ting at 60-80 Hz.

Bass boost control on CAD1000

Bass boost control is used to set

the bass volume. You can select the

amplification between 0 dB and +6

dB.

This function is used to compensate

for the bass box function and to

adjust for your own taste of bass. Set

level control at 0 dB if you want it to

be inoperative.

Remote level control on CAD1000

The audio level can be adjusted from the front seat

by using the remote level control box. Connect the

cable coming with the amplifier between the control

box and remote connector on the amplifier.

LPF

40Hz 125Hz

Bass Boost

0dB

+6 dB

Two 4 ohm subwoofers

2 ohm load

Speaker

Testing

Before you finish the installation, you should do the

following tests to make sure the wiring is correct and

everything is operating properly.

Reconnect Battery

When wiring is complete,

reconnect the battery

negative terminal.

Test power wiring

Turn on the head unit but do not turn up the

volume. The amplifier power light should

come on. If not, check the remote and +12

volt wires. Also check the ground

connection.

Turn up the head units volume slightly. All

speakers should operate. if not, check wiring

connections at amplifier and speakers.

CAD1000