ACP RiderPro Manuel du produit et de l'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du produit et de l'installation pour {nom_de_la_catégorie} ACP RiderPro. ACP RiderPro 17 pages. Motorcycle protection for acp sentry barrier tl-4 thriebeam system

Imprimer la page
9
Installation to the
ACP Sentry ThrieBeam
Guardrail System.
9.1

New installation.

When supplied as part of a new guardrail barrier
installation, prior to commencing the installation of the
RiderPro system, it is recommended that the
installation of the barrier is completed in accordance
with its "Product and Installation Manual".
9.2

Retrofitting installation.

When supplied for the retrofitting of an existing
guardrail barrier, prior to install the RiderPro system, it
is recommended to identify if the Sentry Post has a
RiderPro 12mm mounting hole located 600mm from
the top of the Sentry Post. If the RiderPro mounting
hole is not present in these post be prepared to drill a
12mm hole 600mm from the top of the Sentry Post.
9.3

Sequence of installation.

The major steps in the installation of RiderPro are as
follows:
1. Installing the mounting brackets;
2. Attaching and splicing the RiderPro beams
3. Installing the end terminals; and
4. Adjusting the ground clearance of the beams.

9.4 Attaching the mounting Brackets

Potential Hazards:
Injury from movements and
posture, hand injury from pinch points, strain to wrists
from tightening bolts and excessive noise from use of
impact driver.
Recommended Control Measures:
posture, wear gloves, use an impact wrench to
tighten bolts and wear appropriate hearing
protection.
The RiderPro mounting bracket is attached via
the 12mm mounting hole which is located 600mm
from the top of the Sentry Posts and affixed using
the M10x25mm bolt.
Install the RiderPro mounting bracket now.
Ref: IM 031 Rev 00
Date: 15/07/2021
Page 8/17
Observe correct
Tighten the M10 bolt connecting the
RiderPro mounting bracket to the Sentry
Post to a torque range of 40 to 80 inch-
pounds (4.5 to 9Nm).
Figure 2. ACP Sentry Barrier: Attachment
of Mounting Bracket.
Figure 3. ACP Sentry Barrier: Mounting
Bracket attached (rear view).
Property of
Margaritelli Ferroviaria S.p.A.
06135 Ponte San Giovanni - Italy