Aion Electronics L5 Preamp Manuel - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Aion Electronics L5 Preamp. Aion Electronics L5 Preamp 15 pages. Preamp, overdrive & limiter
Imprimer la page
General Build Instructions
Build Order
When putting together the PCB, it's recommended that you do not yet solder any of the enclosure-mounted
control components (pots and switches) to the board. Instead, follow this build order:
1.
Attach the audio jacks, DC jack and footswitch to the enclosure.
Firmly attach the pots and switches to the enclosure, taking care that they are aligned and straight.
2.
Push the LEDs
3.
into the hole in the enclosure with the leads sticking straight up, ensuring that the flat side
1
is oriented according to the silkscreen on the PCB.
4.
Fit the PCB onto all the control components, including the leads of the LED. If it doesn't fit, or if you need
to bend things more than you think you should, double-check the alignment of the pots and switches.
5.
Once you feel good about everything, solder them from the top
there is no stress on the solder joints from slight misalignments that do not fit the drilled holes. You can
still take it out easily if the build needs to be debugged, but now the PCB is "custom-fit" to that particular
enclosure.
6.
Wire everything according to the wiring diagram on the last page.
For the LEDs: You can use a bezel if you'd like, but generally it's easier just to drill the proper size of hole
1
and push the LED through so it fits snugly. If you solder it directly to the PCB, it'll stay put even if the hole is
slightly too big. Make absolutely sure the LED is oriented correctly (the flat side matches the silk screen) before
soldering, as it'll be a pain to fix later! After it's soldered, clip off the excess length of the leads.
Note on soldering the toggle switch(es): It will require a good amount of solder to fill the pads. Try to be as
2
quick as possible to avoid melting the lugs, and be prepared to feed a lot of solder as soon as the solder starts
to melt. I recommend waiting 20-30 seconds between soldering each lug to give it time to cool down.
Sockets
Since double-sided boards can be very frustrating to desolder, especially components with more than 2 leads,
it is recommended to use sockets for all transistors and ICs. It may save you a lot of headaches later on.
License / Usage
No direct support is offered for these PCBs beyond the provided documentation. It is assumed that you
have at least some experience building pedals before starting one of these. Replacements and refunds will not
be offered unless it can be shown that the circuit or documentation are in error. I have in good faith tested all of
these circuits. However, I have not necessarily tested every listed modification or variation. These are offered
only as suggestions based on the experience and opinions of others.
Projects may be used for commercial endeavors in any quantity unless specifically noted. No bulk
pricing or discounting is offered. No attribution is necessary, though a link back is always greatly appreciated.
The only usage restrictions are that (1) you cannot resell the PCB as part of a kit, and (2) you cannot
"goop" the circuit, scratch off the screenprint, or otherwise obfuscate the circuit to disguise its source.
(In other words: you don't have to go out of your way to advertise the fact that you use these PCBs, but please
don't go out of your way to hide it. The guitar effects pedal industry needs more transparency, not less!)
L5 PREAMP
as the last step before wiring. This way
2
15