Blue Clean 956920 Instructions d'assemblage, d'entretien et d'utilisation - Page 13
Parcourez en ligne ou téléchargez le pdf Instructions d'assemblage, d'entretien et d'utilisation pour {nom_de_la_catégorie} Blue Clean 956920. Blue Clean 956920 17 pages. 1800 psi electric pressure washer
Imprimer la page
care and maintenance
Detergents
• Use detergents designed for power washers.
Hardware stores or home centers also have
power washer detergents for different cleaning
projects. The cleaning solution should be the
consistency of water in order to prevent clogging
your detergent bottle and nozzle.
• This system applies detergent under low
pressure. The cleaning power of the detergents
is enhanced when applied with low pressure
and enough time is given to break down dirt
and grime. The combination of low pressure
and chemical action is very effective and can
be better than scrubbing if applied properly.
ALWAYS spray detergent on a dry surface. DO
NOT pre-soak area. Wetting the surface first
dilutes the detergent and reduces its cleaning
ability. DO NOT allow detergent to dry on
surface. On vertical surfaces being cleaned,
apply detergent to lower surfaces and work
your way up to prevent detergent from causing
streaks in the dirt and grime. Rinse detergent
by pressure washing from bottom up for same
reason.
• If a stain is particularly tough, it may be
necessary to reapply the detergent and use a
bristled brush to scrub the stain. Subsequent
power washing after brushing should
successfully complete your cleaning job.
Cleaning Nozzles
• A clogged or partially clogged nozzle can cause
significant reduction of water pressure coming
out of the nozzle and/or cause the unit to
pulsate while spraying.
• Turn off the unit.
• Turn off the water supply to the unit.
• Relieve any pressure trapped in the hose by
squeezing the trigger 2-3 times, and then lock
the spray gun by pushing the lock button from
left to right.
• The screens inside the adapter should be
cleaned periodically. Rinse it with clean water,
and then place it back in the adapter.
https://www.kipogeorgiki.gr/
• Using the nozzle tip cleaner provided (or an
unfolded paper clip), insert the wire into the
nozzle hole and move back and forth until debris
is dislodged.
• Back flush water through the nozzles using
garden hose and highest pressure available
(either standard water nozzle or use your thumb
over the nozzle to create water pressure for back
flush).
Storage
• When your pressure washing session has been
completed, turn off the power switch located on
the front of the power washer. Unplug the power
cord from the outlet. Turn off the water supply.
Pull the trigger on the spray gun 2-3 times to
drain out the excess water and to release any
remaining water pressure. Disconnect the
garden hose adapter from the water inlet. DO
NOT allow the power washer to run with no water
flowing through it.
• Remove detergent bottle and clean completely.
Residual chemical will stick to the container and
can cause the detergent injector to clog and not
function properly.
• Remove high pressure hose from spray gun..
• Remove lance from the gun. Place the gun in the
holder on the side. Lances are placed into any
of the slots in the back of the unit. Make sure to
discard any remaining detergent from the bottle.
Flush the bottle and nozzle head with fresh
water to prevent clogging.
https://www.kipogeorgiki.gr/
13