Blue Clean 7870 Manuel d'utilisation et d'entretien - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Blue Clean 7870. Blue Clean 7870 20 pages.
Imprimer la page- 1. Table of Contents
- 2. Machine Identification
- 3. Technical Features
- 4. Main Parts
- 5. Safety Regulations
- 6. Machine Installation
- 7. Machine Start up
- 8. Regulation of the Operating Pressure
- 9. Hydraulic System
- 10. Labels
- 11. Maintenance
- 12. Maintenance
- 13. Cooling Coil Internal Cleaning
- 14. Warranty
- 15. Declaration of Conformity
- 16. Declaration of Conformity
AR BLUE CLEAN
The machine is equipped with idle wheels; it it thus recommendable to avoid
•
placing the machine on ramps or slanted floors. Do not tilt the machine by
more than 20 °C (with full tank).
It is forbidden to use plug extensions if the work enviroment is subject to
•
water/humidity presence which could cut the isolating conditions of the system.
Always check the isolation of the electric cable as well as the equipment's
integrity.
In case an extension is required, be sure that plugs and sockets have a
•
protection type IP65 and that the power cord complies with the table reported
here below.
VOLTAGE V
380 - 415
380 - 415
7.
MACHINE INSTALLATION
The machine you are about to use will give you the best performances if you install
itself following our instructions. Before setting the machine at work, make sure that
the machine lies perfectly on a horizontal surface.
Connect the high pressure hose A to the gun B and with the other side of the cable to
the intake fitting, fixing tightly the fastening nut C (see fig. 4).
Connect the lance B1 to the gun B.
USE AND MAINTENANCE HANDBOOK
EXTENSION LENGTH
0 mt UP TO 25 mt
25 mt UP TO 50 mt
C
B1
B
7830 - 7850 - 7870
CABLE SECTION
4x2,5 mm
4x4 mm
A
Fig.4
2
2
page 7