FLAVIA SB100 Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} FLAVIA SB100. FLAVIA SB100 11 pages. Brewer
Également pour FLAVIA SB100 : Manuel de l'utilisateur (14 pages)
Imprimer la page
1.
SWITCH OFF BREWER AND DISCONNECT FROM MAINS
4.
FILL WITH COLD WATER TO MAXIMUM FILL LINE
7a.
CONNECT TUBING
INSIDE TANK
AND SLOWLY
ADD DESCALANT
9.
PRESS AND HOLD
RIGHT HAND ARROW, BUTTON
AND SWITCH ON BREWER
12.
PRESS START BUTTON TO CIRCULATE SOLUTION FOR
TEN MINUTES
15.
WHEN CIRCULATION HAS STOPPED, DO NOT SWITCH OFF MACHINE. CHECK ALL SCALE HAS BEEN REMOVED.
IF NECESSARY, CLOSE PACK DOOR AND PRESS START BUTTONTO RESTART CIRCULATION, THIS MAY BE REPEATED
AS MANY TIMES AS REQUIRED.
WHEN ALL SCALE HAS BEEN REMOVED, EITHER DISCONNECT THE TUBING FROM INSIDE THE TANK (FIG.7A) AND
PRESS THE START BUTTON TO EMPTY TANK INTO A BUCKET OR SINK, OR, SWITCH OFF AND DISCONNECT FROM
MAINS AND POUR AWAY. IN ANY EVENT SWITCH OFF MACHINE FOR AT LEAST 10 SECONDS, FILL WITH COLD WATER
AND REPEAT FROM 9 ABOVE
CAUTION: The use of other descalants other than those specified may cause
damage to your brewer - please read and follow manufacturers instructions
at all times.
PLEASE NOTE: DESCALE TUBING IS REUSABLE
SB100 DESCALE INSTRUCTIONS
WARNING - DO NOT LEAVE THE BREWER UNATTENDED DURING THIS PROCEDURE
2.
REMOVE LID AND CUP STAND
5.
CONNECT DESCALE TUBING INTO FILTERPACK HOLDER
7b.
Recommended Descale Notes
FLAVIA RECOMMEND RENEGITE (MANUFACTURED BY BRAVILOR
BONAMAT) ALTERNATIVELY USE A DESCALANT AVAILABLE FROM ANY
SUPERMARKET OR DIY STORE SUCH AS 'SCALEAWAY' OR 'OZ' DESCALERS.
A descale kit with instructions is available from FLAVIA Customer Service.
Please use the 'Contact Us' form, located in the Customer Service Section
of www.flavia.net.
NOTE: WITH THE ABOVE ALTERNATIVE DESCALANTS, THIS PROCESS MAY
HAVE TO BE FOLLOWED 2 OR 3 TIMES TO SUCCESSFULLY DESCALE YOUR
BREWER.
10.
WHILST HOLDING
RIGHT HAND ARROW BUTTON
PRESS LEFT HAND ARROW BUTTON
13.
A THIRD FLASHING GREEN LIGHT INDICATES
THE SOLUTION IS CIRCULATING
3.
Response
EMPTY CONTENTS OF
BREWER INTO SINK
WARNING - WATER MAY BE HOT
6.
CLOSE FILTERPACK HOLDER
DO NOT PRESS START
BUTTON AT THIS STAGE
8.
RE-FIT AND LOWER
LID. DO NOT CLOSE
11.
Response
IF THE TWO RED LIGHTS DO NOT FLASH AS SHOWN,
SWITCH OFF MACHINE FOR MINIMUM OF 10 SECONDS
AND REPEAT STEPS 9 & 10. TWO FLASHING RED LIGHTS
INDICATE THE PROCESS HAS STARTED. AFTER 40 MINUTES
ONE LIGHT WILL CHANGE TO GREEN.
14.
PRESS AND RELEASE START BUTTON TO ABORT CYCLE
70-40-0410-1
WHEN RINSING
AND DRAINING
ENSURE THE
MESH FILTER IS
FITTED TO PREVENT
LOOSE SCALE
FROM ENTERING
PIPEWORK AND
PUMP
A/W No:1091