Fleck 7000 Manuel d'installation et de démarrage - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de démarrage pour {nom_de_la_catégorie} Fleck 7000. Fleck 7000 12 pages. Birm filter
Également pour Fleck 7000 : Manuel de programmation (4 pages)
Imprimer la pageFleck 7000 Birm Filter Installation & Startup Guide
27. After the Birm Filter has gone through the backwash and rinse, press the Extra Cycle button and
repeat the backwash and rinse. This is the same procedure that needs to be done each time
you add Birm media in the future, that is, the Birm media must be thoroughly backwashed and
rinsed.
28. Refer to your Fleck 7000 service manual for more information about how your control valve is
programmed if desired.
Troubleshooting the Fleck 7000 Birm Filter Filter
One problem that may occur is if you do not have enough backwash flow rate to properly clean the Birm
Filter filter. You can verify the backwash flow rate by running the drain line into a bucket and timing it
when the Fleck 7000 is in Cycle 1 or backwash. A 1.0 or 1.5 cubic foot system should have 5 gallons per
minute and a 2.5 cubic foot system should have 10 gallons per minute of backwash.
In some cases, the Fleck 7000 may not be programmed correctly. See the Fleck 7000 service manual
for instructions on how to access the master programming.
Page 12
www.cleanwaterstore.com
Rev 101812