Fleck 7000SXT Manuel d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Fleck 7000SXT. Fleck 7000SXT 17 pages.

Programming

 Figuring your water

Hardness

 Enter and being

programming

Congratulations! You have completed the installation of your Fleck 7000 SXT

It is now time to being programming. Please follow the step by step

instructions listed below to correctly program your water softener.

It will be important to know what your water Hardness and Iron content is before doing this programming

procedure. If you do not know your water hardness or iron content you should either look up your city

water quality report by going to Google and typing in: water quality report (enter your water supply

company or the city that you are in) , or take a 8 oz sample to a pool supply store to have it tested.

Your Hardness test results may indicate GPG, PPM, or Mg/L. It is important to note that PPM and Mg/L are

the same measure and both figures can be treated interchangeably. If you get a hardness figure in PPM or

Mg/L, please divide this number by 17.1 to get Grains Per Gallon " GPG".

Iron results should also be measured in either PPM or Mg/L. Add your level of iron multiplied by 3. Add this

number to your hardness level. This figure will be your Total hardness content that you will program into

your softener system.

Example:

if water hardness is 10 GPG and the iron is 1 PPM or Mg/L take the iron content of 1 and x 3 = 3 GPG

hardness plus 10 GPG = total compensated hardness 13 GPG

First plug in your 7000 SXT Valve to a nearby outlet. The system will illuminate 4 digits and show the time

of day and the amount of gallons remaining. This display will switch between these values about every 5

seconds.

PLEASE NOTE: The valve below is a 2510 sxt valve but the display should look the same as the 7000 sxt.

Page 8 of 17

Fleck 7000 SXT

http:// www.Qualitywatertreatment.com