AKOS Eros S Manuel d'installation - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AKOS Eros S. AKOS Eros S 20 pages. Insert fireplace

9 Final Inspection

− All connections must be gastight. Check the connections for leakage using a leak detector or

spray.

− Check whether the burner pressure and the inlet pressure measured agree with the data

indicated on the registration plate

Measuring inlet pressure

− Turn off the gas control tap.

− Open the pressure gauge nipple B (see fig. 1.3) a few turns and connect a pressure gauge hose

to the gas control valve.

− Carry out this measurement when the appliance is on at full gas mark and when it is on the pilot

light.

− If the inlet pressure is too high you are not permitted to connect the appliance.

Measuring the burner pressure:

− Only perform this measurement if the inlet-pressure is correct.

− Open the pressure gauge nipple A (see fig.1.3) a few turns and connect a pressure gauge hose

to the gas control valve.

− The pressure must agree with the value indicated on the registration plate. In case of deviations,

get in touch with the manufacturer.

− * Close the pressure gauge nipples and check these for gas leaks.

− Start the pilot and main burner according to the instructions in the user's manual.

− Check whether the pilot light is properly and not covered by chips, an imitation log or pebbles.

− Check the ignition of the main burner at full mark or low mark. (The ignition should take place

quickly and easily).

− If the pilot light is extinguished, either intentionally or unintentionally, no attempt should be made

to relight the gas until at least 3 minutes have elapsed.

AKOS Sp. z o o.

ul. Bruszewska 22, 03-046 Warszawa

NIP: 5361925006; REGON 365653140

Tel: +48881697975; email: [email protected]

Table 1 – Deflector state as a function of flue configuration

17 <