Fleming Music Australia STL 120 Manuel d'instructions de montage - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} Fleming Music Australia STL 120. Fleming Music Australia STL 120 10 pages.

Imprimer la page

3. BRIDGE ASSEMBLY (PART E)

First, let's clean up the main pickup cavity by running the black and white

wires through the 14" hole into the control plate cavity.

Run the blue ground wire (Part F) through the small hole in the top of the body

below the main pickup area. When it emerges in the main pickup cavity push

it through the hole in the side wall into the control plate cavity. Notice that the

blue wire is formed into a loop will be wound around the centre screw that will

be used to attach the bridge assembly. This will ground the circuit.

There are two wires attached to the lead pickup assembly. One is red and the

other is yellow. These wires will also be run through the hole from the lead

pickup cavity to the control plate cavity.

Attach the bridge assembly to the body using three 1" screw. Install the centre

screw first, carefully wrapping the exposed end of the ground wire around it.

Control Plate (Part G)

The cavity for the control plate should now look like a spaghetti factory with

five wires hanging out! This wiring is colour coded to match the wiring on the

control plate itself.

Slide a piece of shrink tubing (if available) on each wire and connect black to

black, white to white, red to red etc. Carefully slide the shrink tube over the

connection and heat the tubing with a match to permanently seal the

connection.