AkoTec Weiser Protect Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AkoTec Weiser Protect. AkoTec Weiser Protect 20 pages.

Attention

The f ixed point of the pipeline should be determined when using rigid piping so that

suff icient expansion of the collector header pipe is possible. The rigid piping must NOT

be shortened. The continuing connections must be supported after a length of max. 15 cm.

Notes on the continuing pipeline

Do not solder on the collector and the supplied terminals. The design of the collector

must not be changed.

For installation, use only components that are suitable for the high temperatures that

occur, for example, gunmetal and brass f ittings, copper and stainless steel pipe.

When using hemp, use only pressure and temperature resistant solar sealant.

When using compression f ittings, all tube ends must be square and deburred. Push the

union nut and the clamping ring onto the tube and wet the threads with a little oil. Push

the tube as far as it will go into the compression f itting. First tighten the

union nut by hand and then tighten by ¾ turn.

Mounting the sensor

insert the sensor into the sensor immersion sleeve

connect with heat shrink tubing

shrink the shrink tubing with a heat source or wrap it with the protective f ilm provided

page 12