DOD VoFX Manuel du propriétaire - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DOD VoFX. DOD VoFX 16 pages. Vocal fx processor/mic pre

Signal Processing

• by turning the Data wheel in Performance mode.

To select Programs using the footswitches:

1) After you power up, the VoFX defaults to Performance mode. Select a Bank by

pressing the Bank selector footswitch. The display shows the selected bank

number on the left side of the display and a dash on the right. The display

might look something like this:

2) Press footswitch 1, 2, or 3. The dash in the display changes to show the

number of the Program you selected. The display might look something like

this:

NOTE: If a new Program number is not selected within 5 seconds after pressing

the Bank select button, the display returns to its previous setting.

Editing Programs

As you become more familiar with the VoFX, you may find that you need to

modify certain Programs to better fit your needs. Fortunately, the VoFX is flexi-

ble enough to give you everything you need without being difficult to program.

The following procedure is an example of how to modify your Programs.

Suppose that a Program which has a 100 ms mono delay, a medium chorus,

noise gate, EQ, Mic Driver, and compression sounds close to what you want,but

you want a 300 ms delay with low feedback instead. Here's how to change it:

1) Use the Data wheel, or the Bank and Program selector footswitches to select

the desired Program.

2) Press the Delay effect group button. The Delay group Status LED begins

flashing and the display reads: