DOD SR823 Manuel du propriétaire - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DOD SR823. DOD SR823 10 pages. Sr series

SR Crossover

NSTALLATION

** Be sure to begin installation with all AC power to your sound system

turned off.

Install the crossover in a rack using the provided rack screws and washers.

Route the AC power cord away from audio lines and plug into a convenient

outlet. Connect audio lines to the crossover using the appropriate input jacks

to channels 1 and 2 (for stereo operation) or to channel 1 (for mono

operation). Connect the appropriate output jacks for stereo 3-way, mono 4-

way operation (SR834 only), or stereo 2-way, mono 3-way (SR823). The rear

panel is clearly marked for proper connection. Follow the top labels for stereo

connection or the bottom labels for mono connection.

All inputs and outputs are balanced. Use XLR type male plugs for inputs and

female plugs for outputs. For balanced operation using 1/4" phone plug

connectors, use only tip-ring-sleeve (stereo) jacks. For unbalanced operation

using 1/4" phone plug connectors, use only tip-sleeve (mono) jacks.

FOR BALANCED CONNECTION:

Wire XLR connections as follows:

Pin 2: high

Pin 3: low

Pin 1: ground or common

FOR UNBALANCED AMPLIFIER CONNECTION:

To make an

unbalanced connection to the unit's XLR connectors, wire the line

connectors as follows:

Pin 2: high

Pin 3: NO CONNECTION

Pin 1: ground

Use tip-sleeve 1/4" phone plug connectors for connection to the amplifiers,

wired as follows:

tip: high

sleeve: ground

Once the crossover is installed, adjusted, and tested, an optional security

panel may be secured to the front panel of the unit to prevent tampering.