Etac Molift MRS Duo 3500 Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Etac Molift MRS Duo 3500. Etac Molift MRS Duo 3500 12 pages.
Imprimer la page
Adjusting post heights
1. Lift the inner post and pull out quick release
bolt.
2. Lift post to desired height and insert quick
release bolt trough outer post.
3. Look at height labels and ensure that both
post are adjusted at the same height.
Don`t stand under boom when
adjusting post height
Make sure quick release bolt is
properly installed
Don`t lift boom any higher when
stop sign appears on height label
End stops
1. Lead the end stops to the desired position and
tighten them.
2. Make sure the liftmotor does not hit the post.
3. Use allen key (located in top of post) to screw
in bolts.
Assembly
Mounting charger to post
1. Remove plugs from holes on the post.
2. Use the small allen key (located in top of post)
to fasten screws.
3. Fasten the lower screw first.
4. Place charger on screw and insert second bolt.
Check list before use
Don`t start using MRS Duo before
completing control according to
checklist after assembly.
Use this checklist to verify that the MRS Duo is
properly installed and can operate correctly and
safely before use.
Make sure both bolts in foot are properly
fastened.
Make sure all four bolts on boom are prop
early fastened.
Make sure quick release bolts are correctly
installed
Make sure end stops are properly fastened
6
Molift MRS Duo / www.etac.com