Acqua GY-NE280FRW Manuel d'instruction - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Acqua GY-NE280FRW. Acqua GY-NE280FRW 13 pages.

__________________________________________________________________________________

Temperature

inside is too warm

Temperature

inside is too cold

Doors will not

close easily

Units is too hard to

open

Water drips on the

floor

Disposal of the Appliance

Packaging Materials

Packaging materials with the recycle symbol are recyclable. Dispose of the packaging into a

suitable waste collection container to recycle this.

Before Disposal of the Appliance

1. Pull out the mains plug from the mains socket.

2. Cut off the power cord and discard with the mains plug.

Warning! Refrigeration appliances contain refrigerant and gases in the insulation.

Refrigeration and gases must be disposed of professionally as they may cause eye injuries

or ignition. Ensure that tubing of the refrigerant circuit is not damaged prior to proper

disposal.

__________________________________________________________________________________

You may have left the doors open too long or too frequently; or the

doors are kept open by some obstacle; or the sides appliance is

located with insufficient clearance at the sides, back and top.

Increase the temperature by following the "Display Controls"

section in the manual.

Check whether the top of the appliance is tilted back by 10-15mm

to allow the doors to self-close, or if something inside is preventing

the doors from closing. Are the seals pushed into the grooves

properly.

This happens because a slight and temporary vacuum occurs when

warm air is let into the appliance when the door is opened. This gets

flash cooled by the frozen product inside causing the vacuum. Wait

30 seconds or use your fingertips to press on the seal to help ease

the vacuum. Do not pull on the door as you will damage your seal

and may cause your door handle to loosen or come off!

The water pan located at the rea bottom of the cabinet may not be

properly levelled, or the draining spout located underneath the top

of the compressor depot may not be properly positioned to direct

water into this pan, or the water spout is blocked. You may need to

pull the appliance away from the wall to check the pan and spout.