3M 4382 Instructions - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions pour {nom_de_la_catégorie} 3M 4382. 3M 4382 2 pages. Cabinet ground bar replacement

Imprimer la page

1.0 General

The 4082/4382 Cabinet Ground Bar

Replacement Kit is used to improve grounding

capabilities in these cabinets.

2.0 Kit Contents

1 - Bonding Bar

2 - Lower Rib

3 - Ground Connector

4 - Screw, Hex Head 10-32

5 - Washer, Flat #10

6 - Stud, 10-32

7 - Nut with Washer

Important Notice

All statements, technical information and recommendations related to the Seller's products are based on information believed to

be reliable, but the accuracy or completeness thereof is not guaranteed. Before utilizing the product, the user should determine

the suitability of the product for its intended use. The user assumes all risks and liability whatsoever in connection with such use.

Any statements or recommendations of the Seller which are not contained in the Seller's current publications shall have no force

or effect unless contained in an agreement signed by an authorized officer of the Seller. The statements contained herein are

made in lieu of all warranties, express or implied, including but not limited to the implied warranties of merchantability and fitness

for a particular purpose which warranties are hereby expressly disclaimed.

SELLER SHALL NOT BE LIABLE TO THE USER OR ANY OTHER PERSON UNDER ANY LEGAL THEORY, INCLUDING BUT

NOT LIMITED TO NEGLIGENCE OR STRICT LIABILITY, FOR ANY INJURY OR FOR ANY DIRECT OR CONSEQUENTIAL

DAMAGES SUSTAINED OR INCURRED BY REASON OF THE USE OF ANY OF THE SELLER'S PRODUCTS THAT WERE

DEFECTIVE.

34-7028-8817-2

3M TelComm Products Division

PO Box 2963

Austin, TX 78769-2963

Qty.

3.0 Installation

3.01 Remove rivets attaching plate to block frame.

3.02 Remove rivets attaching ground bar to cabinet.

3.03 Mount the new ground bar in the same location

as old ground bar using two (2)10-32 studs,

inserting from exterior and placing washer nuts

(2) on inside, tightening securely. Attach ground

connector on top surface of ground bar using hex

head 10-32 screw placing it over hole. Place

three (3) more hex head 10-32 screws from top

side in three remaining threaded holes in ground

bar placing a washer on each hex head screw.

3.04 On the block frame, attach the plate in the same

position as the old, noting the position to allow

clearance for the new ground bar connector.

Fasten to the frame with four (4) round headed

10-32 screws, inserting again from exterior

placing washer nuts (4) on inside. Tighten

securely.

903925

1990 3M

Litho in U.S.A.