Acqua GY-NE242RF Manuel d'instruction - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Acqua GY-NE242RF. Acqua GY-NE242RF 20 pages.
Imprimer la page
10
Troubleshooting
OPERATION
Starting up and temperature
regulation
•
Insert the plug of the connection
lead into the plug socket with
protective earth contact. When
the refrigerator compartment
door is opened, the internal
lighting is switched on. After
the fridge has been placed in
position, wait for 5 minutes
before electricity is supplied.
Don't store anything until the
temperature inside the fridge
becomes low enough, at least 2
hours.
•
The temperature selector knob
is located on the right of the
refrigerator compartment.
Setting 0 means:
Off.
Clockwise rotate the knob to turn on
the appliance.
Setting 1 means:
Highest temperature, warmest
setting.
Setting 7 (end-stop) means:
Lowest temperature, coldest setting.
Important! Normally we advise
you select setting of 2, 3 or 4,
if you want the temperature
higher or colder please turn the
knob to warmer or colder setting
accordingly.
Important! High ambient
temperatures (e.g. on hot summer
days) and a cold setting (position 6
to 7) may cause the compressor to
run continuously or even non-stop!
Reason: when the ambient
temperature is high, the compressor
must run continuously to maintain the
low temperature in the appliance.
Changing the LED light
If the LED light is damaged we
recommend it being repaired by a
qualified registered electrician.
If the LED light needs to be replaced,
do not look directly into the light
with an optical instrument to avoid
eye injury. If the LED light strip is
not functioning after being replaced,
consult a qualified registered
electrician.
•
Before changing the LED light,
switch off the appliance and unplug
it, or pull the fuse or the circuit
breaker.
•
LED light data: 220-240V Max 2W
•
Unplug the mains plug.
•
To change the LED light, undo the
screw.
•
Changing the defective LED light.
•
Put the refrigerator back into
operation.