Dodge 2011 Ram 5500 Manuel d'utilisation et d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} Dodge 2011 Ram 5500. Dodge 2011 Ram 5500 17 pages. 2011 chassis cab

Imprimer la page

PTO Operation & Installation Guide

LEARNING SET SPEED

NOTE: This Feature Requires Engine Calibration Software released in December

2008:

If your vehicle was produced before December 2008, you must have the dealer "Reflash"

the engine controller to December 2008 or later engine software.

In order for this feature to work the PTO MUST be wired as REMOTE PTO (pto

switch between F425 and V937) not standard PTO.

Key ON (Engine not running)

Press and release Cruise SET button 5 times within 10 seconds

Start Engine (Engine Running)

Go into IDLEUP Mode (Cruise ON then SET to go to 900 RPM)

Set the desired speed (using cruise switches)

Press Cancel

Turn key off (to save the setting)

UNLEARNING SET SPEED

Key ON (Engine not run)

Press and release Cruise Set button 5 times within 10 seconds.

Note: To LEARN a new speed, first UNLEARN the old speed

Once the idle speed is LEARNED, the engine will go to that idle speed whenever

the Remote PTO switch is turned on, without additional operator assistance.

PTO will engage first and then the idle speed will ramp up to the LEARNED

speed, thus not violating the AISIN requirement of not allowing PTO engagement

above 1000 RPM.

The LEARNED speed is saved at power down.

2011 Chassis Cab

01/22/2010

ALL

OUT