Clinton C-6314 Manuel du propriétaire et manuel d'instructions - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et manuel d'instructions pour {nom_de_la_catégorie} Clinton C-6314. Clinton C-6314 16 pages. 2 cycle engine

Imprimer la page
PRECISION BUILT
Your Clinton Engine has been preci­
sion built and specifically engineered to
the purpose of your equipment. It has
been carefully inspected throughout all
phases of its production and assembly by
men who are devoting their lives to the
production of fine air cooled gasoline en­
gines. Your Clinton is the finest two cycle
gasoline engine of its type that money
can buy.
CARBURETION
The carburetor (see Fig. No
.1)
on
your engine is of the latest design, engi­
neered and, calibrated exactly for your en­
gine to assure you of the best possible
performance and efficiency. The standard
float-type carburetor or the economy suc­
tion-type, may be selected for use on
your
engine,
depending upon the
rnanufacrurer
of your equipment
and/or
the eng
ine
ap­
plication.
IGNITION
The magneto used on your Clinton
(see Fig. ,No.7) is a flywheel type which
produces high voltage at cranking speeds
to insure easy
starting.
This magn
eto
gives
positive protection from dirt, dust and
moisture accumulating
in
the magneto
and assures trouble-free performance in
starting your Clinton when it is subjected
to high humidity and dusty conditions
COOLING
An air blast created by the rotation of
the finned flywheel is directed over the
cooling fins on the cylinder block and
head.
This results in an exceptionally cool
running engine.
LUBRICATION
The oil (SAE #30 motor oil-mineral),
which is combined with gasoline in the
proper amount in the fuel mixture (see
"Fuel Preparation for Clinton 2-Cycle
Engines
") ,
is distributed to the bearings
and moving parts of the engine requiring
lubrication. Since
clean fresh oil is being
continuously
supplied to the engine in
the fuel mixture, there is no necessity for
re-circulation
of used oil. After the oil in
the fuel is once used for lubrication, it is
immediately burned up in the combustion
chamber and discharged through the ex­
haust pOrt.
GOVERNOR
Your Clinton engine is equipped with
a positive automatic (air controlled
)
gov­
ernor which insures a controlled and con­
stant speed under all operating condi­
tions. The governor allows the engine
to
operate at the same speed with or without
the load to which the engine is being sub­
jected.
The engine speed will not exceed
the predetermined
setting"
.
This means
that your engine will always operate at
the proper speed and will not run "wild,"
resulting in less wear and fewer repairs.
SERVICING FACILITIES FOR YOUR CLINTON ENGINE
If your engine requires expert adjusting and repair service, contact your
local factory approved Clinton authorized service station, which you will find
listed in the classified section of your telephone directory under "Engines-Gasoline."
You may als
o
refer to the authorized ser
vice
directory that comes with your en­
gine. It lists the more than 3500 authorized service sta tio ns - deale
rs
who carry
a complete stock of
g
e
nuine replacement parts and
a
re factory trained to give
you the
best
possib le service for your engi
ne.
Only the listed factory approved
service stations
a
re a
uthorized
to perform warranty repairs and adjustments.
4