Clinton Electronics CE-PVM2MPF Manuel de l'utilisateur - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Clinton Electronics CE-PVM2MPF. Clinton Electronics CE-PVM2MPF 19 pages.
Imprimer la page
IP CAMERA
/
Codec Settings
• VBR+ : Has a higher compression rate than VBR. The effectiveness will be maximized if the video is less
dynamic. Depending on the decoding software or hardware used, the VBR+ video stream data may not
display correctly. If necessary, consult with the decoding software or hardware manufacturer.
Image Quality : With VBR or VBR+ set, you can reduce bandwidth further by lowering the image quality.
Bit-rate : Adjust the average size of the encoding video. Enter a value within a range of 512 Kbps ~ 15,000
Kbps.
Boost Quality : When a Motion Detection event is triggered, the camera's FPS/Bit-rate/GOP value is changed
into the specified Boost FPS/Bit-rate/GOP value.
• Boost FPS : Sets the frame rate when motion is detected.
• Boost Bit-rate : Sets the bit rate when motion is detected.
• Boost GOP Size : Set the GOP Size when motion is detected.
Video Format : Select either NTSC or PAL video format.
Output Bandwidth Limit : You can select whether to limit bandwidth or not.
• MAX Bandwidth : Specifies the peak bandwidth. Enter your desired value if selecting <ON> for Bandwidth
Limit. Enter a value within a range of 1,000 kbps~30,000 kbps.
Supplementary : Used to set up the Frame Per Second reception rate differently for the 1st/2nd video
streaming.
• Use : Sets whether to use Supplementary.
• Original stream : Sets the default video stream.
• FPS : You can set the frame rate of the camera image.
Use the charts below as a reference for bit rate values with some common resolutions and frame rates. These
are recommended starting bit rate values and should be adjusted accordingly to meet the requirements of the
install network.
Resolution
1920 x 1080 (2MP)
1280 x 720 (720p)
704 x 480 (D1)
Resolution
1920 x 1080 (2MP)
1280 x 720 (720p)
704 x 480 (D1)
Exclamat NOTE:
• Codec Settings do not effect the main image of the PVM. These settings only effect the network stream(s).
• If selecting H.265: Ensure the connected equipment supports the H.265 codec.
H.264 Bit-rate Guide (Kbps)
30 fps
25 fps
4096
3500
2048
1792
1024
896
H.265 Bit-rate Guide (Kbps)
30 fps
25 fps
2048
1792
1024
896
512
448
20 fps
15 fps
2800
2048
1536
1024
640
512
20 fps
15 fps
1536
1024
768
512
384
256
10 fps
5 fps
1536
768
768
384
384
192
10 fps
5 fps
768
384
384
192
192
96
7