CLINTON INDUSTRIES 1190E Manuel - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CLINTON INDUSTRIES 1190E. CLINTON INDUSTRIES 1190E 19 pages.

7.1.0 Using the Built-in Test Program

To enter: Press simultaneously the ARROW- RIGHT and the SBT button., release the

ARROW-RIGHT button first! Otherwise you are back in the main program!

The display should read:

To go to the first group, press the "ARROW-ROUND" button

The display reads:

Then it reads the position of the threadle:

This can be:

If the threadle is in forward position, the displayed number is the reading of the

ADC- converter.

The lowest number should be below ten (10) and the highest number at least 245

To go to the next group, press the "ARROW-ROUND" button again

The next group is:

Turn the hand wheel and the display reds all 3 positions:

NEEDLE-UPor/ NEEDLE-DOWN or TRIM

To go to the next group, press the "ARROW-ROUND" button again

The next group is:

Then activated inputs are displayed

If no inputs are activated, the display reads " ---------------- "

To go to the next group, press the "ARROW-ROUND" button again

The next group is:

After two seconds, the display reads:

To activate the output, press the "NEEDLE-UP / NEEDLE-DOWN button.

To go to the next output, press the "ARROW-UP" button.

The next reading is;

To go to the next output, press the "ARROW-UP" button.

To go to the former output, press the "ARROW-DOWN" button

TEST MODE

TEST TREADLE

1. NEUTRAL

2. FORWARD and a number

HEEL 1

HEEL 1 / HEEL 2

test synchronizer

test inputs

(this will be displayed for two seconds)

test outputs

-1- PRESSERFOOT

- 2 – NEEDLE COOLER

for about 2 seconds