Dodge SLEEVOIL RXT Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Dodge SLEEVOIL RXT. Dodge SLEEVOIL RXT 12 pages. Pillow blocks with self lubrication
Également pour Dodge SLEEVOIL RXT : Manuel d'instruction (12 pages)

Imprimer la page
Dodge SLEEVOIL RXT Manuel d'instruction
Table 4 - Torque Value for Housing Hardware (in.-lbs.) ft.-lbs.
Housing
3
4
Size
Housing
(2000)
(3600)
to
167
300
Pedestal
Bolts
Housing
(1560)
(2280)
to
130
190
Cap Bolts
5. INSTALLATION OF HOUSING CAP
Position shims on each side of housing. Put a short strip of
Plastigage (3 inches) on liner spherical ribs at top of each rib of
liner and near the middle of spherical ribs.
NOTE: New housing shims are required with replacement
liners.
CAREFULLY set housing cap in place.
NOTE: Align dowel pin and dowel pin hole in housing halves
before lowering cap onto base.
5
6
8
(4600)
(8400)
(11500)
383
700
958
(2280)
(2280)
(3240)
190
190
270
PLASTIGAGE
Tighten housing cap bolts to torque specified in Table 4.
Remove cap bolts and housing cap.
10
(15000)
1250
(3240)
270
Compare the width of the deformed Plastigage with the inch
scale on its wrapper. This indicates the clearance between
housing and liner.
Shims provided are multiple layers of .002 inch thickness each.
Separate and remove layers, per Table 5. Do this for both shims.
This will provide a controlled interference fit between housing and
liner (.003 to .004 in. crush desired).
Table 5 - Clearance Measured, Shims Removed
Clearance Measured
(Inches)
0.001
0.002
0.003
0.004
0.005
Align shims as required. CAREFULLY replace housing cap.
Torque cap bolts to values specified in Table 4.
6. SEAL INSTALLATION
Apply sealant to seal mounting surfaces of housing.
4
PLASTIGAGE
Shims Removed
2
3
3
4
4
MOUNTING
SURFACE