Cliplight 580952 Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cliplight 580952. Cliplight 580952 2 pages. Combustible gas leak detector

Imprimer la page

The Leak Detector will default to the NORM sensitivity level automatically once the unit comes out of the warm up cycle and the

green LED will turn on.

To change sensitivity levels, press the SENS once for HI sensitivity (red LED will turn on) and again for LO sensitivity (yellow LED

will turn on).

Leak Test Vial

The leak detector comes with a Leak Test Vial that allows

the user to ensure the detector is performing properly. To

test:

Remove the plastic seal cap on the Leak Detector Vial

by pulling it off (see Fig. 1)

Turn on the detector and allow the unit to complete

the warm up cycle.

Place the sensor close to the small hole in the top of

the Leak Test Vial. The beep rate should increase and

the Digital Leak Size Indicator should display a

number from 4-6 indicating that the sensor and

electronics are working properly.

Maintenance

Batteries:

Install Batteries: Remove screw located at rear end of unit

and pull down hinged battery door to open as shown. Always

insert all four batteries into the battery compartment in

the same direction. Note polarity mark on the inside of the

battery door for proper battery orientation.

Sensor:

Replace Sensor: Remove sensor by unscrewing sensor cover.

Install the new sensor by aligning the notch in sensor

socket with the raised tab on sensor socket holder. (see

figure below).

Note:



Do not force sensor into socket. Misalignment can

damage the sensor pins.



Ensure sensor is fully inserted for proper operation. The

detector will stay in warm-up mode and the on/off

switch will become inoperative if the sensor becomes

loose or is not fully inserted.

Adjusting Sensitivity Levels

Unscrew cover to replace sensor

Push straight on (do not twist) to

install sensor

Warranty Policy

The 580952 Combustible Gas Leak Detector is warranted to be free of

defects in materials & workmanship for two years from the date of

purchase. This warranty applies to all repairable instruments that have

not been tampered with or damaged through improper use including

unauthorised opening of the unit.

Fig. 1

NOTE: always remember to

replace plastic seal cap after

leak test is completed. Replace

Test Vial when the green

colour is no longer visible.