ClipperCreek ChargeGuard EX Mode d'emploi

Parcourez en ligne ou téléchargez le pdf Mode d'emploi pour {nom_de_la_catégorie} ClipperCreek ChargeGuard EX. ClipperCreek ChargeGuard EX 2 pages. Hcs

Imprimer la page

ChargeGuard

ClipperCreek HCS EVSE to an existing building access control or

other third party access control system. With ChargeGuard

a momentary contact closure driven by successful authentication

in an access control system can activate the HCS ChargeGuard

EX enabled station for a single charging session. Alternatively,

maintaining the contact closure will leave the station enabled for

multiple charging sessions until the connection is released.

When the orange and yellow control wires are shorted together, the

EVSE is "ON" and ready to charge a vehicle. When the wires are

disconnected, the station is "OFF" and requires a valid activation

through the access control system in order to begin charging again.

ChargeGuard

1. If individual access control is desired (for each charge

session), the access control system will need to provide

a momentary short to the orange and yellow wires

which will activate the station for a single charge

session. In this implementation once the vehicle is

disconnected the station will require a successful

authorization through the access control system.

2. If open access is desired, connect the orange and yellow

wires for as long as open access is desired. As long

as the orange and yellow wires are shorted together, the

station will be enabled for use.

EX HCS INSTRUCTIONS

EX provides a simple interface to connect the

EX can be utilized in two ways:

Page 1