ClipperCreek CS EVSE Pedestal Manuel d'installation - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 pages. Electric vehicle supply equipment
Imprimer la pageMOUNTING THE EVSE(s)
10..
EVSE Knockout Removal
•
To open the EVSE door, remove the two door
screws on the left side of the EVSEenclosure
using a T15 Torx driver.
•
Unlock the safety latch found on the bottom of
the EVSE enclosure and swing the door open.
•
Carefully knock out the molded knockout
found at the bottom left corner of the rear wall
of the CS EVSE enclosure for the wiring and
conduit entrance. Refer to Figure.14.
•
Repeat on second EVSE if a Dual Mount.
Figure.14:.EVSE.Knockout.Position
Use Rear Wall
Knockout
CS EVSE PEDESTAL INSTALLATION GUIDE
11..
Mounting a Single EVSE to the Pedestal
With the mounting plate and back bracket in place,
the pedestal is now ready for a single EVSE to be
mounted. For a dual EVSE Installation, proceed to
Step.12.
This operation should be performed by two
installers, one to hold the EVSE in place
while the other secures the pedestal hardware
•
Place a 1/4" Neoprene-bonded sealing washer
around the shaft of four (4) 1/4" - 20 x 1" Torx
button-head screws. The metal portion of the
washer should face the head of the screw
while the neoprene should face the tip of the
screw.
•
Pull the three conductor wires into the
enclosure and insert the threaded end of the 90
degree conduit fitting into the open aperture.
•
Align the four screw holes on the side flanges
of the EVSE with the corresponding screw
holes in the mounting plate and the
thread inserts on the back bracket.
•
Secure the EVSE to the pedestal mounting
plate and bracket with the four (4) 1/4" - 20 x
1" Torx button-head screws (with washers) `
using a T27 Torx driver.
Figure.15:.Mounting.a.Single.CS.EVSE
Page 15
ClipperCreek
, Inc.