Dog trace d-control 1040 Manuel - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Dog trace d-control 1040. Dog trace d-control 1040 18 pages. Electronic vibration training collar
Également pour Dog trace d-control 1040 : Manuel d'instructions (15 pages)

Imprimer la page
Dog trace d-control 1040 Manuel
Turn on your transmitter.
Select dog 1 on the remote controller.
Touch the lower part of your remote controller to the target on your receiver (see the photo
on page 30). The green LED will be permanently lit and after some 3 seconds, it will switch to the
programming mode, indicated by flashing of the red and green LED at the same time.
Now take your transmitter away and press down the sound signal button
controller. The codes will be matched in this step and your receiver will produce a sound signal.
Proceed in the same way when programming the second receiver (for the second collar for d-control
642, 1042, 1642 models).
REPROGRAMMING OF YOUR RECEIVER
The receiver can be programmed repeatedly without restraint either using the same remote controller or
with another (see the section Programming /coding/ the transmitter with the receiver).
TIP: It is possible to program an unlimited number of receivers to one transmitter, which is possible to
use for training of several dogs at the same time. It is possible to record two transmitters into one
receiver, which can be used, for instance, for a potential correction of the dog's training by an instructor.

Transmitter - button functions

The Dogtrace d-control remoter controller is designed for cooperation with two separate receivers
independent of each other (dog 1 or 2 selection).
Button - Tone signal
When you press down the tone signal button, you will be able to send the tone signal to your receiver at
a long distance. There is no time limit for this function: The buzzer will sound for as long as you are
holding the pressed down button and the green LED on your receiver will be permanently lit. It will be
indicated by the transmission symbol on the LCD display of your remote controller.
on your remote
31