Dog trace d-control 1502 mini Manuel de l'utilisateur - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dog trace d-control 1502 mini. Dog trace d-control 1502 mini 20 pages. Electronic training collar

Imprimer la page

Button

-Booster

Pressing the „Booster button" enables you to use different levels of pre-set stimulation intensity at the

transmitter. The stimulation is transmitted by the two contact points located on the receiver as long as

the button is pushed. If the button is not released after 4 seconds, the stimulation will automatically

turn off as a safety feature. The receiver will be ready to be reactivated once the button has been

released. While pressing, an indicator of the radio transmission will appear on the LCD display of the

transmitter; the indicator light on the receiver goes from flashing green to permanent red.

Programming the „Booster button":

press the selection button



on the LCD display.

press the



press the selection button



select dog

using the button on the transmitter and proceed in the same way (applicable when



programming „Booster function" for the second receiver).

Up/Down control buttons

The control buttons are used for quick adjustment of the stimulation level of the receiver. The selected

intensity level is shown on the LCD display. There are 30 stimulation levels with 1 being the lowest and

30 being the highest. When any button is pressed the LCD display lights up for three seconds.

Dog selection buttons

The control buttons 1 and 2 are used for quick dog selection when using the device for training two

dogs simultaneously. It is possible to set different level of stimulation for each dog

for approximately 5 seconds until the level of stimulation flashes

button to increase or decrease the level of stimulation.

to confirm the level selected.