Dog trace d-control 200 mini Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dog trace d-control 200 mini. Dog trace d-control 200 mini 20 pages. Electronic training collar – basic training set for one dog. electronic training collar – basic training set for two dogs – with a carrying case
Imprimer la page
INSERTION (REPLACEMENT) OF THE BATTERY IN THE TRANSMITTER
Observe polarity when installing the battery. Reversing the battery will damage the transmitter. Use
only lithium
batteries.
CR2 3V
Remove the transmitter battery cover using a cross-head
screwdriver.
If replacing the battery, remove the old battery and dispose of it
properly.
Place the lithium
CR2 3V
Put the battery cover back into place and secure with screw.
The battery level is shown at the battery life status bar on the LCD
display.
Battery fully charged: full battery icon is shown on the LCD display.
Low battery: battery empty icon is shown on the LCD display.
Prepare a spare lithium
described in the section "Insertion (replacement of the battery in
the transmitter".
Choosing the contact points
The stimulation is delivered through the receiver contact points. Two different series of contact points
are supplied. The length of the contact points must be sufficient to have proper contact with the dog's
skin, enabling the device to operate correctly. If you have a short-haired dog use the short 12 mm
contact points, if you have a long-haired dog replace them with the longer 17 mm contact points
supplied with the kit. Carefully tighten them manually (do not use a key). It is possible to purchase the
21 mm long contact points.
battery in the holder and press into place.
battery and follow the instructions
CR2 3V
TIP
TIP: You can easily lift up the battery using
the small flat-head screwdriver.
Battery polarity marks
7