Dog trace d-control 500 mini Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dog trace d-control 500 mini. Dog trace d-control 500 mini 19 pages. Electronic training collar
Également pour Dog trace d-control 500 mini : Manuel de l'utilisateur (20 pages)

Imprimer la page

INSERTION (REPLACEMENT) OF THE BATTERY IN THE TRANSMITTER

Remove the transmitter battery cover using a cross-head screwdriver.



If replacing the battery, remove the old battery and dispose of it properly.



Place the alkaline AA 1,5V batteries in the holder and press into place. Observe polarity when



installing the batteries. Reversing the batteries may damage the transmitter.

Put the battery cover back into place and secure with screw.



THE BATTERY LEVEL IS SHOWN AT THE BATTERY LIFE STATUS BAR ON THE LCD DISPLAY.

Battery fully charged: full battery icon is shown on the LCD display.



Low battery: battery empty icon is shown on the LCD display.



Prepare two spare alkaline AA 1,5V batteries and follow the instructions described in the section

„Insertion (replacement of the battery in the transmitter".

Choosing the contact points

The stimulation is delivered through the receiver contact points. Two different series of contact points

are supplied. The length of the contact points must be sufficient to have proper contact with the dog's

skin, enabling the device to operate correctly. If you have a short-haired dog use the short 12 mm

contact points, if you have a long-haired dog replace them with the longer 17 mm contact points

supplied with the kit. Carefully tighten them manually (do not use a key). It is possible to purchase the

21 mm long contact points.