CYKLOP LIGOTECH LGT 260 Manuel d'utilisation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CYKLOP LIGOTECH LGT 260. CYKLOP LIGOTECH LGT 260 16 pages. Battery-operated hand tool for plastic strapping

Imprimer la page

Battery-operated Hand Tool LGT260 for Plastic Strapping

Battery Charging:

Insert the battery to be charged

into the charger slot and plug it

into a power supply, as shown in

the figure on the right.

Warning:

Insufficient battery power may lead to insufficient welding of the packing straps

Please cut off the strap if the strap welding is not enough!

The battery must be charged before using the tool again.

5.2 Operation Function Description

5.2.1 Operation Panel And Buttons

Start preparation:

1. Operation panel unlocking and locking:

Plug in the power supply (battery), and the tool is in the locking state, at this time

any button on the operation panel is invalid.

Unlocking Method for the Operation Panel: Press the button DEC (for about 2s),

and then press the Welding button to unlock it after hearing a sound of Beep.

After parameters are set, you can also press the button DEC for 2s, and then press

the Welding button to lock the operation panel after hearing a sound of Beep.

Note: The tool will enter the locking state again if no operation is performed

within 30s after the tool is unlocked.

2. Waking-up from the sleep state:

The tool will changes to the sleep mode if no operation is carried out within 120s

after the tool is unlocked, and all the indicator lights go out. All buttons will be invalid,

except the button Tensioning A1. To wake up the tool, short press the button Tensioning

A1 to restore it to the standby mode.

At this time, the machine can work normally. If it is necessary to modify the

previously set parameters, please refer to the "Operation panel unlocking", unlocking

the operation panel and then modifying the parameters.

User Manual

Battery-operated Hand Tool LGT260 for Plastic Strapping

Mode selection(MODE) and working status indicator:

Operation mode selector (MODE):

There are three operation modes: Manual(MAN), Semi-

automatic(SEM) and Fully automatic(AUT).

The corresponding indicator light will be on when a mode

is selected, and indicator lights of different colors mean

different working status.

Status indicator lights:

Blue light always-on: means the tool is normal, standby;

Red light flashing: means insufficient power, indicating

the battery has to be charged;

Red light always-on: means tool failure, please power it

off and check;

Purple light on for a short time: indicates completion of

the packing work

Tension force setting(SET)：

Levels 1-9: 400N-2800N

Welding time setting(INC&DEC):

Used to set a welding time, INC is to increase time,

and DEC to shorten time, interval value: 0.5-3.5 seconds.

Tensioning mode selection:

Normal Mode H: The blue indicator light is on;

Soft Mode L: The yellow indicator light is on.

Battery indicator: Displays the remaining battery capacity

(all light on means the battery full charged.)

Buttons:

Button 1: Tension Button

Button 2: Welding Button

Rocker lever:

Holding up the rocker lever, you can lift the tension wheel;

retract the strap or stop the tool in an emergency.

User Manual

Yellow

Blue

Light On:

Tension

Light On:

Soft

Mode

Normal

Battery

Mode L

Indicator

Mode H

Indicator

Mode

Tension

Welding

Selector

Strength

Time