Dogtra 1902S Manuel du propriétaire - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dogtra 1902S. Dogtra 1902S 17 pages. Available in 2-dog system

Imprimer la page

3. Collar Fitting

Proper Fit

The collar should be fitted so that the surgical stainless

steel contact points press firmly against the dog's skin.

You should be able to fit a finger in between the contact

point and your dog's skin. The best location is on either

side of the dog's windpipe.

Improper Fit

A loose fit can allow the collar to move around on the

dog's neck. When this happens, the contact points may

rub against the skin and cause irritation. If the collar is

too loose, the contact will not be consistent and cause

the corrections to be inconsistent. Dogtra uses surgical

stainless steel contact points and anti-microbial plastic to

protect the dog's skin.

Attention!

Leaving the receiver/collar in the same location on the

dog's neck for an extended period of time can cause

skin irritation. If the dog is to wear the e-collar for long

periods, occasionally reposition the collar so that the

contact points are moved to a different location on

the dog's neck. Make sure you check for skin irritation

each time you use the unit.

4. Finding the Right Stimulation

The 1900S has a Rheostat Dial on the top of the

transmitter (0 is the lowest and 127 is the highest).

Remember that you will need to adjust the setting (upward

or downward) depending on your dog's temperament and

threshold for stimulation. Always start at the lowest level

and work your way up. The appropriate level can be found

when the dog responds to the stimulation with a mild

reaction. Also, as the dog's attitude changes, especially

during times of increased excitement or distraction, you

may need to adjust the intensity level.

NOTE: The stimulation intensity can be adjusted even

while the stimulation is in use.