Dogtra E-Fence 3500 Manuel du propriétaire - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dogtra E-Fence 3500. Dogtra E-Fence 3500 16 pages.

3. Finding a Wire Break Using an RF Choke

RF Choke

e-fence boundary wire

connector tab. Turn up the transmitter signal strength to full

to approx. AM530 on the dial) with the volume turned up. Walk

slowly along the path of the boundary wire while holding the radio

directly over the boundary wire close to the ground as possible.

You should hear a whirling/static noise where the boundary wire

is intact and no whirling noise where the break is located.

Fixing the Break

Once you have found the break, cut out the damaged area and use

a weatherproof gel style wire splicer to reconnect the wires. If the

break is large, or if you cannot identify the break location, you

may need to splice in some extra wire to bypass the area that is

damaged.

Choke and an AM radio tuned to

AM530. Go to the wall mount

transmitter and disconnect the

two boundary wire leads from the

RED connector tabs. In place of

each boundary wire lead, connect

one end of the RF Choke. Next,

take the two boundary wire leads

and reconnect them into the RED

General Maintenance Tips

Your system requires very little maintenance. The receiver/collar

for the E-Fence 3500 system is fully waterproof. To remove dirt,

simply wipe with soap and water.

The wall transmitter is not waterproof and must be protected from

the elements in a shed, garage or carport.

Do not attempt to dismantle or repair the wall mount transmitter

or receiver/collar : this will void the manufacturer's warranty.

These components contain computerized circuitry that should be

serviced only by an authorized expert.

Caution

could void the user's authority to operate the equipment.