Dogtra surestim plus+ series Manuel du propriétaire - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Dogtra surestim plus+ series. Dogtra surestim plus+ series 20 pages. Remote controlled dog training collars

Imprimer la page

BASIC MAINTENANCE

Be sure the rubber-charging cap is securely in place

when the collar is in use. After each training session,

carefully inspect the unit for any missing parts or

damage to the casing. Damaged or broken casing may

affect the waterproof guarantee on the unit. After

confirming there is no damage to the casing, rinse the

receiver/collar and clean out any dirt or debris.

Storage maintenance

Your unit should be fully charged for 10 hours before

storing for extended periods. While in storage, the unit

should be given a full charge once a month, and before

the first use. Store the units in room temperature. Do

not keep the units exposed to extreme climates.

Troubleshooting

If the unit is malfunctioning, please refer to the

"Trouble shooting Guide" before sending it to Dogtra

for service. If you have any questions or concerns, you

may email them to [email protected], or call customer

service at 1-888-811-9111.

TROUBLESHOOTING GUIDE

1. My dog is not reacting to the collar.

- Make sure the receiver/collar is turned on. To turn the

receiver/collar on, place the red dot on the back of the

transmitter to the red dot on the receiver/collar. Hold

the two red dots together until the LED indicator light

on the receiver/collar comes on.

- Be sure the strap is on the dog tight enough so that both

contact points are touching the dog's skin.

- The contact points may be too short for your dog's

thick or long coat. To place an order for longer contact

points you can visit Dogtra's online store at

shop.dogtra.com or call customer service at 1-888-811-

9111. If you are already using longer contact points,

you may need to trim the hair on the dog's neck, so that

both contact points are touching the dog's skin.

- The intensity level may be too low for your dog.

Increase the stimulation until the dog responds, usually

by a neck movement, head shaking, or by looking over

the shoulders. The response may be very subtle.

2. The LED indicator light comes on, but I do not feel

any stimulation.

- Your tolerance may be higher than your dog's. You

may need to try the unit on your fingertips where

sensitivity is higher and/or increase the stimulation