ASEPT 10976 Manuel de l'utilisateur - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} ASEPT 10976. ASEPT 10976 8 pages. Touchless uni dispensers

Imprimer la page

Tips & Troubleshooting

Product not dispensing?

Make sure dome is primed properly.

Make sure lid is seated properly.

Activate the safety switch.

Prevent leaks:

Ensure that dome is pushed fully into pump housing.

Ensure that you hear a CLICK when attaching pump to

pouch.

Unable to place the lid on the dispenser?

The dispensing mechanism includes a safety

switch that will freeze the actuator in posi-

tion if the lid is removed in the middle of

dispensing.

Reset the actuator:

1) Remove the pump and pouch from the

dispenser base.

2) Install the dispensing mechanism and lid

on the empty base.

3) Wave your hand over the sensor.

4) After the actuator cycles completely,

remove the dispensing mechanism and

lid, and reinstall the pump and pouch

into the dispenser base.

5) Reinstall the dispensing mechanism and

lid.

Can I change the portion on the Touchless UNI Dispenser?

No, it is preset at ¾ fl oz at the factory.

Can I plug the Touchless UNI Dispenser into a power strip?

Yes, each dispenser only draws 2 amps when in use. You can safely plug 7 dispensers

into a power strip on a single 15 amp plug and 10 dispensers into a 20 amp plug.

Why doesn't the motor engage when I wave my hand over the sensor?

1) The sensor is designed to dispense when your hand is between 1" and 5" above the

sensor. If it's too close or too far away, the sensor might not recognize your

hand. Try moving your hand up and down on the sensor to see if it triggers.

2) Make sure that the power supply is plugged into a working outlet.