Clockaudio CU 2 Manuel de l'utilisateur
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Clockaudio CU 2. Clockaudio CU 2 2 pages. An intelligent battery management system designed for use with clockaudio cw 9004t, cw 9005t and cw 9006t wireless base transmitters
Imprimer la pageP R O F E S S I O N A L M I C R O P H O N E S Y S T E M S
CU 2
An Intelligent battery management system designed for use with Clockaudio CW 9004T, CW 9005T and
CW 9006T wireless base transmitters.
CAUTION: Always
turn off the wireless
microphone
transmitter before
putting the
transmitter in to the
charger.
Place
transmitter in
to charging
bay
Processor controlled
Built-in active monitoring system
Temperature sensor
Dedicated compartments for
charging two CW 9004T, CW
9005T or CW 9006T
Must be used with AC power
adaptor supplied with each CU 2.
Red LED
(Checking
battery)
Red LED
flashing
(FAULT -
battery)
Red LED flashing
(FAULT - safety
time limit
exceeded)
User Guide
1) Insert one or two wireless microphone transmitters in to the charger with the metal charging
points facing down. See fig 1
2) There are two LEDs. The LED closest to the power supply input is for the charging bay on the
right. The LED furthest away from the power supply input is for the charging bay on the left.
The LED will light up red to show that the transmitter in that charging bay is charging. See fig 2
3) The transmitters are charged independently. Each transmitter may take up to 8 hours to charge
depending on the capacity of the batteries and how flat the batteries are.
4) The LED will light up green when the transmitter in that charging bay is fully charged. See fig 3
5) The fully-charged transmitter can be removed and replaced with another transmitter that
requires charging, even if there is a charging transmitter in the other charging bay.
Fig 1
Fig 2
www.clockaudio.com
Fig 3