Cymbol G3-IP-2MPVPD-M Manuel rapide - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Cymbol G3-IP-2MPVPD-M. Cymbol G3-IP-2MPVPD-M 13 pages. G3 series ir vp dome camera
Imprimer la pageMicro SD memory slot on the Board
Card Slot for Micro SD memory: Socket "J15"
•
Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
•
Connecting Alarms
AI(Alarm In) :
You can use external devices to signal the network camera to react on events. Mechanical or
electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G(Ground) :
Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.
Alarm Out :
The network camera can activate external devices such as buzzers or lights. Connect the device
to the AO (Alarm Out) and G (Ground) connectors.
•
Connecting the Power
Connect the power of DC12V or AC24V for the network camera. Connect the positive(+) pole to
the '+' position and the negative(-) pole to the '-' position for the DC power.
Be careful not to reverse the polarity when you connect the power cable.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the
camera.
The heater will operate properly only by the power source of AC 24V.
If using PoE, the heater will not operate at all.
If PoE and DC 12V are both applied, this camera will get supplied with power from PoE.
•
Connecting Service Monitor Port
Service monitor output port (J7) is located on the board of the dome camera, and is used for an
easy OSD setup.
▶ ID & IP assignment
To make changes in the OSD menu, please the OSD controller provided optionally with your
camera purchase. You can set Camera Title and IP Address.
Quick Installation Guide
4