DogWatch The Bark Collar BT-7 Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DogWatch The Bark Collar BT-7. DogWatch The Bark Collar BT-7 16 pages. No-bark trainer
Également pour DogWatch The Bark Collar BT-7 : Manuel du propriétaire (16 pages)
Imprimer la page
1. Turn 'on' the BarkCollar (page 4) and turn the dial to the
lowest setting - either Vibration ('V') or Low ('1').
2. Put the collar on your dog (page 6).
3. To determine the appropriate setting, you will need
to observe your dog barking. When your dog barks,
look for some kind of response such as a head shake,
ear twitch, change of expression or any change in the
pattern of barking.
The sensation from the collar should be just enough to
distract the dog's attention away from barking.
IMPORTANT
There is a brief 'bark forgiveness' delay before the
●
collar activates, so the response will not be immediate.
The vibration or stimulation gradually increases
●
(within each setting) as the dog continues to bark,
so the response may not happen immediately.
The response should be subtle.
●
4. If you do not see a response after allowing your dog to
bark for several minutes, increase to the next setting.
5. Allow your dog to bark again at the new setting and
watch for a response, as noted above. Repeat steps until
you observe a response.
Increase only one setting at a time.
FINDING THE APPROPRIATE SETTING
7