DogWatch PT4 Manuel

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DogWatch PT4. DogWatch PT4 2 pages.

The transmitter sends a coded digital FM radio signal through the boundary wire. This

signal can be adjusted, allowing you to control the "hidden fence" around your property.

Rate

Adjustment

Power

On/Off

Bottom View

Power Supply

Never adjust the transmitter while your dog is wearing the receiver collar.

1. Power On/Off:

The red Power light on the front panel lets you know that it is operating.

2. Power Supply:

with the transmitter. The power supply is plugged into a properly grounded 110 volt

outlet and the adapter is plugged into the "PWR" jack on the bottom of transmitter.

PowerPak™: The optional PowerPak battery back-up keeps the transmitter

operating in the event of a power failure. When the transmitter is being powered by

the battery back-up, the red power light will remain off. The PowerPak plugs into the

transmitter at "P-PAK".

4. Ground Wire:

labeled "GND." The round connector on the green ground wire is attached under

the screw on the outlet faceplate. It will, however, only be effective if your outlet is

properly grounded. If you have any questions about having a properly grounded

outlet, consult your local electrician.

5. Boundary Loop Plug:

plug fits into the hole marked "Loop" on the bottom of the transmitter. This is the

beginning of the boundary wire that is buried in your yard. After the boundary wire

has been properly installed and plugged into the transmitter, the Range and

Boundary Loop Monitor light will turn on.

PT4 Transmitter Features

PowerPak™

This switch gives you easy access to turn the transmitter on or off.

The transmitter is powered by the power supply/adapter provided

The green ground wire connects to the transmitter at the location

Your system includes a zip cord with a plug on one end. This

Ground Wire

Boundary Loop Plug

Training

Mode Switch

Range

Control

Range & Boundary

Loop Monitor

Display